Convert a 2-seat Bushranger into a 3-seat Bushranger with a middle seat. The seat can then be easily removed if you want to use the centre section for extra storage. 

Both the middle seat by itself or a middle seat and backrest kit are available to purchase as an after-market accessory to allow you to convert your Bushranger canoe from a 2 seater to a 3 seater. Most people choose to just fit the seat (not the backrest) as it is an easier fit-out that does not require any alterations to the 2 seat set-up.

Instructions for fitting and removing the middle seat of a Bushranger Canoe

NOTE: The weld hole underneath the seat goes towards the rear of the canoe. 

• Place the seat into the middle of the centre cockpit of the canoe with the edge of the seat closest to your feet and angled away at 45 degrees.
• Place a tyre lever (or large screw driver) between the seat and the opposite side of the canoe and pull the tyre lever towards you while pushing on the seat. The side of the canoe will flex out approx 50mm (2") to allow the seat to slip into the canoe. 
• Push the seat towards the rear of the centre cockpit.
   
• To remove the seat, move the seat towards the centre of the cockpit and reverse the process.

Please note: 

A Middle Seat Kit is available that includes a plastic backrest to be attached to the back of the cockpit. (This also involves removing the thwart that supports the deck between the cockpits).

Permanently fitting a middle seat to a Bushranger requires a custom-made jig to make sure that the holes n the canoe match up with the inserts in the seat so we do not recommend that you try it at home.